varnish load balance - HLS

Laszlo Danielisz laszlo.danielisz at yahoo.com
Thu Oct 30 23:02:18 CET 2014


It turned out that by changing the timeout the backends stays healthy!





> On 30 Oct 2014, at 08:28, Andreas Plesner Jacobsen <apj at mutt.dk> wrote:
> 
>> On Fri, Oct 24, 2014 at 12:53:33PM -0700, Laszlo Danielisz wrote:
>> 
>> Timeout is set to 1 second for each probe
>>    0 Backend_health - backend1 Still healthy 4--X--- 3 3 5 0.000000 0.000000 HTTP/1.1 200 OK
> 
> Please paste full config. Varnish concludes that your backend is down after
> 0.000000 seconds, so either it times out, or there's something it doesn't like
> the responses your backend sends.
> I'm thinking it may be the latter, so a packet dump of a probe would be nice,
> or perhaps just a hex dump of an http request matching the probe.
> 
>> Here is a varnishlog -O 
> 
> While you were doing a request? If so, then your request is not reaching
> varnish. Check netstat and firewalls.
> 
> -- 
> Andreas
> 
> _______________________________________________
> varnish-misc mailing list
> varnish-misc at varnish-cache.org
> https://www.varnish-cache.org/lists/mailman/listinfo/varnish-misc



More information about the varnish-misc mailing list